I'm working on a verilog project(Not C I know, But I think this transfers over. Haven't found a good verilog board yet)
So i'm working through some demo code/ best practices to try to do a little learning and I havnt seen this before:
Code:
assign HEX7 = 7'h7f;
assign GPIO_1 = 36'hzzzzzzzzz;
A <= 4'b0000;
A <= A + 1'b1;
specifically the numbers. I think 1'b1 is binary 1. is the number before the ' the base and the number after the number? still seems odd to do things in base 36 and 4.
any help is greatly appreciated! thanks!