ADSL Communication Module

The small and compact ADSL module-IB01, is an ideal choice for embedded application. It can be applied in handheld devices, high-end broadband router, embedded broadband communication systems. The working power consumption is 2.3 watt, and when standby, only 2 watt.
With powerful MIPS32 microprocessor, 240 Mhz. High-efficient DC/DC circuit inside, reducing power consumption effectively and greatly improving ADSL module working stability. Build in a series of interfaces including USB device interface (USB 1.1), Ethernet interface, Serial port interface, and I / O's. Users can use commands to configure and manage via Web page/ Telnet/ CLI.
IB01 supports full rate, auto-negotiation ADSL, ADSL2 and ADSL2+ standards, which can be automatically identified and switched. Downstream rate of 24Mbps (ADSL2 / 2 +), max transmission distance up to 5.5km.

Features
1. High performance, high integrated and compact DSL module
2. Powerful MIP32 CPU, very low power consumption mode
3. Full duplex, auto-negotiation 10/100M Base-T
4. Dial-up modes: bridge and PPPoE/PPPoA
5. High-efficient DC/DC circuit inside, power consumption is at least 25% lower than normal ADSL Device
6. Support 16MB Flash and 64MB SDRAM
7. Multifunctional interface, set aside few I / O Interfaces
8. Support RS232 CLI control (TTL)
9. Embedded design to ensure stability of the system



Hardware interface
ADSL － 2 pin 2.54mm, no polarity
Ethernet － 4 pin 2.54mm, 568B standard
Serial(RS232) － 2 pin 2.54mm, as CLI

Software
Communication standard
ANSI T1.413 Issue 2
ITU G.992.1 A (G.dmt)
ITU G.992.2 A (G.lite)
ITU G.994.1 (G.HS) in ADSL layer
ITU G.994.1, G.996.1
ITU992.5(ADSL 2+)

Encapsulation protocol
Ethernet Over ATM ( MpoA, RFC 1483 Bridge Mode )
Ethernet Over ATM ( MpoA, RFC 1483 Router Mode )
PPP Over ATM ( PPPoA, RFC 2364 )
IP Over ATM ( CLIP, RFC 1577 )
PPP Over Ethernet ( PPPoE, RFC 2516 )

Dimension: 80x 60x 14mm ( 3.15x 2.36x 0.55 inch)

Aaaaaaaaaaaaaaaaaaaaaaaaaaaaand deleted.