Printable View
Hi everyone , Can u pls help me programming pic18f452 using C code , I need to send 40 victors to pic ports, e.g ( 20080) where, 2=port A , 0=port B , 0= port C , 8= port D , 0= port E. Delay for 3 second and send another different vector till all 40 vectors or commands finished. Looking forward to hearing from any one. Thanks in advance
What have you tried so far?
In particular, have you tried to send just ONE thing to ONE port?
Steps
1. Learn which C Compiler you are using
Note: Microchip C18, Hi-Tech C, and a few others; each use a slightly different time delay setup.
2. Learn to use simulation in MPLAB IDE (watching the ports value is real important)
Note: Common Mistake forgetting to set the proper speed of MCU.
3. Write a program that outputs a single byte to a port
Note: Common Mistake not setting up port to be a output.
4. Find out how to do a time delay
Note: Are you going to use a routine supplied by the Compiler or write your own using hardware interrupts.
Note: I would NOT recommend that you write your own.
Note: If compiler supplied delay, you are likely to need to wrap it in a for loop since most compiler delays are for only fraction of seconds max.
5. Write a program that outputs a second byte to a port after waiting the delay time.
6. Create an constant array of 40 bytes needed for the port
6B. use a for loop to increment though the array.
7. Create the other arrays one per each port
8. Program the real MCU; instead of using Simulator
Tim S.
Thanks Tim S, that was good advice , I will try to follow that.
Hi all, I am trying to learn programming pic 18f452 , can any one help in writing code to shift a bit through a byte? and how can I do that separatly with each port, thanks in advance.