Printable View
Hello,
I'm writing some code where i mix assembler and C.
Now i'm stuck trying to get a value from a register(in assembly) to a variable(in C such as a char).
so:
asm out 0x44, al; say this was the last assembler instruction
char value;
value= what's in 0x44 how do i do that?
Thanks in advance :)
According to this, Turbo C automatically substitutes the correct instructions when it finds C tokens in your asm.
Quote:
C Symbols
You can use C symbols in your asm statements; Turbo C++ Inline assembly automatically converts them to appropriate assembly references to data language operands and appends underscores onto and functions identifier names. You can use any symbol, including automatic (local) variables, register variables, and function parameters.
In general, you can use a C symbol in any position where an address operand would be legal. Of course, you can use a register variable wherever a register would be a legal operand. If the assembler encounters an identifier while parsing the operands of an inline assembly instruction, it searches for the identifier in the C symbol table. The names of the 80x86 registers are excluded from this search. Either uppercase or lowercase forms of the register names can be used.
so according to your quote, this should work, right?
int value;
asm out value, al;
unfortunately it doesn't work. :( i get: Invalid combination of opcode and operands
however,
asm mov value, 0x01
works just fine (at least it compiles)
any ideas?
Use mov.
Since you couldn't figure out this on your own and mov is one of the first and most fundamental operations in all of assembly....perhaps you should study up a bit on assembler before trying to use it. I might also add it would be a good idea to get a compiler that was created within the last decade or so.
I'm programming for the casio calculator which is based on the 286 processor thus the need for a prehistoric compiler.
Well, yes , i got almost zero experience with the x86 instruction set, i just need to use it to access the serial port which is not accessible from C because of the hardware configuration of the calculator.
The mov comand sends the value '0x01' to the variable but i want to send the contents of a register to a variable.
In Turbo C there were some predefined variables like _EP that give access to registers directly from C - no need in assembler here...Quote:
Originally Posted by trennonix
I do not exactly remember the names - help should answer that (I haven't touched Turbo C more than 15 years...)
Thanks alot! now I got it working.
Mov will work for both directions.
The 'value' would be assembled as say something like: dword ptr[ebp-4]
so the line:
out value,al
be assembled as:
out dword ptr[ebp-4],al
but there is no opcode for this as it is illegal using the 'out' mnemonic:
you can only have either an immediate value or edx as the first argument:
out 220,al
or
out edx,al
so if you wanted to open 'value' port you could:
mov edx,value
out edx,al
I don't think the OP was talking about sending data to/from ports.