Printable View
Hello everyone,
Mentioned in the book -- "CLR via C#", page 15, chapter 1 "The CLR's Execution Model",
--------------------
the C# compiler will emit NOP (no-operation) instructions into the code. The NOP instructions are emitted to enable edit-and-continue feature while debugging.
--------------------
What means "edit-and-continue" feature? Why emitting NOP instructions will facilitate this feature?
thanks in advance,
George
When you debugging application and step on some line of code likeQuote:
What means "edit-and-continue" feature
if(x == 1)
and you see that this line should be
if(x != 1)
you change this line, stop debugging, compile the code from stratch and run the Application in the debug mode again.
edit-and-continue feature gives the possibility just to edit theline and continue debugging - it replaces several instructions that are modified due to your fix and continue debugging using the new code
Because the new code could be a little longer thatn the old one - a few NOP instruction could be useful
Thanks vart,
1.
I used this feature before and I do not know it is called "edit and continue". :-)
I can understand your below points that new code could be longer than old one, but why adding a new NOP instruction (I think you mean a place holder?) will make things convenient?
2.
User may add as much as possible the instructions, I am wondering how many NOP instructions will compiler generate in advance? :-)
Quote:
Originally Posted by vart
regards,
George