serial port communication
Thank you for u r reply,
i will definitely check the hyper terminal with COM1 port,
but my actual question is how to connect the printer to the COM1 port,
still i have not connected it,what is the procedure,
as i have set of procedure how to connect hyper terminal , how to configure it through COM1 is there any way to connect the printer,
please tell me.
serial port communication
dear experts,
thank u for reply,
ya i understood know,as u suggested i used the Hyperterminal to check whether COM ports are working, for that i used one serial cable ,
but it worked for following configuration of COM1
Bits per second :9600
Data bits :8
Parity :none
Stopbits :2
Flow control :xon/xoff
so my question is whether i can use this configuration and use that serial cable
and and use my program to communicate between 2pcs, and also what is the configuration that i have to replace for Flow control:xon/xoff which was 0 previously.
what are u r suggestions insead of printer is it possible to make communication between two pcs, please give me u r suggestion, how to do, whether one
hyperterminal and one program or running program on both the PCs,
please help me.
serial port communication
dear experts,
really sorry for my post if it is really felt very bad to you,
as i intially said i dont know anything about serial port communication and i am following the steps what u were referring me,
anyhow my actual task was to do a serial communication with printer, but after checking everything i found that serial printer was not available so i thought of atleast communicating in between two PCS, for that your hyperterminal concept had helped me,
once again if you felt this thread is useless or wasting your time i am extremely sorry, thanks for all your replies.