Like Tree1Likes
  • 1 Post By gretayj

ADSL Communication Module

This is a discussion on ADSL Communication Module within the Networking/Device Communication forums, part of the General Programming Boards category; The small and compact ADSL module-IB01, is an ideal choice for embedded application. It can be applied in handheld devices, ...

  1. #1
    Registered User
    Join Date
    Dec 2011
    Location
    Shenzhen, China
    Posts
    1

    ADSL Communication Module

    The small and compact ADSL module-IB01, is an ideal choice for embedded application. It can be applied in handheld devices, high-end broadband router, embedded broadband communication systems. The working power consumption is 2.3 watt, and when standby, only 2 watt.
    With powerful MIPS32 microprocessor, 240 Mhz. High-efficient DC/DC circuit inside, reducing power consumption effectively and greatly improving ADSL module working stability. Build in a series of interfaces including USB device interface (USB 1.1), Ethernet interface, Serial port interface, and I / O's. Users can use commands to configure and manage via Web page/ Telnet/ CLI.
    IB01 supports full rate, auto-negotiation ADSL, ADSL2 and ADSL2+ standards, which can be automatically identified and switched. Downstream rate of 24Mbps (ADSL2 / 2 +), max transmission distance up to 5.5km.

    Features
    1. High performance, high integrated and compact DSL module
    2. Powerful MIP32 CPU, very low power consumption mode
    3. Full duplex, auto-negotiation 10/100M Base-T
    4. Dial-up modes: bridge and PPPoE/PPPoA
    5. High-efficient DC/DC circuit inside, power consumption is at least 25% lower than normal ADSL Device
    6. Support 16MB Flash and 64MB SDRAM
    7. Multifunctional interface, set aside few I / O Interfaces
    8. Support RS232 CLI control (TTL)
    9. Embedded design to ensure stability of the system



    Hardware interface
    ADSL - 2 pin 2.54mm, no polarity
    Ethernet - 4 pin 2.54mm, 568B standard
    Serial(RS232) - 2 pin 2.54mm, as CLI

    Software
    Communication standard
    ANSI T1.413 Issue 2
    ITU G.992.1 A (G.dmt)
    ITU G.992.2 A (G.lite)
    ITU G.994.1 (G.HS) in ADSL layer
    ITU G.994.1, G.996.1
    ITU992.5(ADSL 2+)

    Encapsulation protocol
    Ethernet Over ATM ( MpoA, RFC 1483 Bridge Mode )
    Ethernet Over ATM ( MpoA, RFC 1483 Router Mode )
    PPP Over ATM ( PPPoA, RFC 2364 )
    IP Over ATM ( CLIP, RFC 1577 )
    PPP Over Ethernet ( PPPoE, RFC 2516 )

    Dimension: 80x 60x 14mm ( 3.15x 2.36x 0.55 inch)
    mark99 likes this.

  2. #2
    Gawking at stupidity
    Join Date
    Jul 2004
    Location
    Oregon, USA
    Posts
    3,167
    Aaaaaaaaaaaaaaaaaaaaaaaaaaaaand deleted.
    If you understand what you're doing, you're not learning anything.

Popular pages Recent additions subscribe to a feed

Similar Threads

  1. functions anywhere? (in the module)
    By Mnemonist in forum C++ Programming
    Replies: 3
    Last Post: 03-05-2010, 12:03 AM
  2. Module Help!
    By J-Camz in forum C Programming
    Replies: 10
    Last Post: 11-27-2008, 07:29 PM
  3. module without using %
    By KIBO in forum C++ Programming
    Replies: 9
    Last Post: 01-16-2008, 10:24 PM
  4. module.h
    By podiyan in forum Linux Programming
    Replies: 3
    Last Post: 10-24-2007, 05:53 AM
  5. Xbee module USB board communication
    By ghost1 in forum C Programming
    Replies: 1
    Last Post: 11-27-2006, 04:19 PM

Tags for this Thread


1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21